First of all, pick up the frame of the child twisting car, you can clearly see a hole in the front part of the frame, then the front wheel of the child twisting car from the bottom of the frame up through the hole, and then Sponge sleeves fit into the front axle, continue to push, aim at the hole in the top of the front body of the frame, and then lightly tighten the front wheel. Then, insert the steering wheel into the receiving hole of the front wheel's upper shaft. The steering wheel should be aligned with the front wheel. Moms should pay attention to the small wheels in the front wheel. A step down.
Next, the steering wheel and the front wheel should be fixed. In the use of the gifted installation tool, the sleeve is inserted into the screw in the steering wheel, and then slowly tightened in a clockwise direction. Be sure to pay attention to the screws used in the steering wheel. It is an expansion screw. Be sure to tighten it so that the baby will not be in danger of accidental safety during use. For aesthetic reasons, cover the specially designed cover after tightening the screws fixing the steering wheel and the front wheel.
Finally, to install the rear wheels of the children's twist car, we must first turn the frame over. Then, after installing the rear wheels of the child twist car, the mothers can clearly see that there is a bayonet on the rear wheel to align the card. After the mouth, insert the rear wheel into the rear wheel hole of the twist frame of the child. When installing the rear wheel, pay attention to the direction of the rear wheel. Because the correct installation of the rear wheel must be in the shape of a figure eight, it must be clearly distinguished to avoid mistakes. As a result, the installation was erroneous and resulted in a reinstallation; the reinstallation would have a disadvantage because the child twisted the rear wheel with a bayonet, which was subject to breaks caused by loading and detachment. After inserting the rear wheel into the rear wheel hole, turn the frame over to the front so that the rear wheel touches the ground, and then hit the rear wheel against the ground so that the rear wheel actually snaps into the body. After the installation is completed, be sure to try the child's twisting car first, and if it is firmly installed, be sure to stabilize it before using it safely to avoid accidents during use.
(Buy baby stroller, baby carriage wholesale, sales, find China Baby Vehicle Industry Network /, Tel 0551-82363313)
For more news, please pay attention to China WeChat Industry Network WeChat public number
Mask bowl can be divided into wooden mask bowl, mask brush bowl set, mask plastic bowl, silicone mask bowl according to the material. It is used to hold the mask to make the mask more uniform and not waste.Pour the mask powder into a bowl, add a proper amount of water and mix thoroughly, apply it on the face, and wash after more than ten minute.Face Mask Bowl And Brush,Facial Mask Bowl And Brush,Ceramic Face Mask Bowl,Skin Care Mask Bowl
Face Mask Bowl,Makeup Bowl,Diy Mask Bowl,Mask Bowls,Mask Mixing Bowl,Silicone Mask Bowl,Wood Mask Bowl,Bamboo Mask Bowl
Shenzhen Nanfang Shishang Cosmetic Utensil Co., Ltd. , https://www.nfbrush.com